To configure features on the system, use the show commands specifically for these features. Refer to the
Exec Mode show Commands chapter in the Command Line Interface Reference for complete information.
Important
Service Configuration
Verify that your service was created and configured properly by entering the following command:
show service_type service_name
The output is a concise listing of the service parameter settings similar to the sample displayed below. In this
example, a P-GW service called pgw is configured.
Service name : pgw1
Service-Id : 1
Context : test1
Status : STARTED
Restart Counter : 8
EGTP Service : egtp1
LMA Service : Not defined
Session-Delete-Delay Timer : Enabled
Session-Delete-Delay timeout : 10000(msecs)
PLMN ID List : MCC: 100, MNC: 99
Newcall Policy : None
Context Configuration
Verify that your context was created and configured properly by entering the show context name name
command.
The output shows the active context. Its ID is similar to the sample displayed below. In this example, a context
named test1 is configured.
Context Name ContextID State
------------ --------- -----
test1 2 Active
System Configuration
Verify that your entire configuration file was created and configured properly by entering the show
configuration command.
This command displays the entire configuration including the context and service configurations defined
above.
Finding Configuration Errors
Identify errors in your configuration file by entering the show configuration errors command.
This command displays errors it finds within the configuration. For example, if you have created a service
named "service1", but entered it as "srv1" in another part of the configuration, the system displays this error.
ASR 5500 System Administration Guide, StarOS Release 21.4
98
Verifying and Saving Your Configuration
Service Configuration
To Next Page
Loading...
Need help?
General
