EasyManuals Logo
Home>Cisco>Network Router>ASR 5000 Series

Cisco ASR 5000 Series Administration Guide

Cisco ASR 5000 Series
508 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #300 background imageLoading...
Page #300 background image
Enabling Congestion Control Redirect Overload Policy
To create a congestion control policy and configure a redirect overload policy for the service, apply the
following example configuration:
configure
congestion-control
context context_name
{service_configuration_mode}
policy overload redirect address
end
Notes:
Optional: If the congestion control policy action was configured to redirect, then a redirect overload
policy must be configured for the service(s) that are affected.
There are several service configuration modes that you can configure. See the Command Line Interface
Reference for a complete list of modes.
You can set various options for redirection. See the Command Line Interface Reference for more
information.
Repeat this configuration example to configure overload policies for additional services configured in
the same context.
Verify the Service Overload Policies
To verify that the service overload policies were properly configured enter the following command in the
Exec Mode:
[local]host_name# show service_type name service_name
This command lists the entire service configuration. Verify that the information displayed for the "Overload
Policy" is accurate.
Repeat this configuration example to configure additional services in other contexts.
Verify the Congestion Control Configuration
Verify MME Congestion Action Profiles
To verify MME multilevel congestion action profiles, run the following Exec mode command:
[local]host_name# show lte-policy congestion-action-profile { name profile_name | summary }
Disconnecting Subscribers Based on Call or Inactivity Time
During periods of heavy system load, it may be necessary to disconnect subscribers in order to maintain an
acceptable level of system performance. You can establish thresholds to select subscribers to disconnect based
on the length of time that a call has been connected or inactive.
ASR 5500 System Administration Guide, StarOS Release 21.4
268
Congestion Control
Enabling Congestion Control Redirect Overload Policy

Table of Contents

Other manuals for Cisco ASR 5000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 5000 Series and is the answer not in the manual?

Cisco ASR 5000 Series Specifications

General IconGeneral
BrandCisco
ModelASR 5000 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals