2-82
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
OL-9772-05
Chapter 2 Message and Recovery Procedures
PLATFORM_WCCP Messages
PLATFORM_WCCP Messages
Error Message PLATFORM-WCCP-3-NO_LABEL: Cannot allocate WCCP Label
Explanation The WCCP label could not be allocated. This means that the hardware cannot be
programmed to implement WCCP redirection.
Recommended Action Reduce the number of interfaces configured for WCCP redirection or policy
based routing.
Error Message PLATFORM-WCCP-4-SDM_MISMATCH: WCCP requires sdm template routing
Explanation The SDM routing template must be enabled to support this feature.
Recommended Action Modify the SDM template to enable the routing template. Use the sdm prefer
routing global configuration command, and then reload the switch by using the reload privileged
EXEC command.
PM Messages
Error Message PM-2-LOW_SP_MEM: Switch process available memory is less than [dec]
bytes.
Explanation The available memory for the switch processor is low. This can occur when too many
Layer 2 VLANs are configured. [dec] is the available memory.
Recommended Action Remove VLANs from the system to reduce memory usage.
Error Message PM-2-NOMEM: Not enough memory available for [chars].
Explanation The port manager subsystem could not obtain the memory it needed to initialize the
specified operation. [chars] is the port manager operation.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error
Message Traceback Reports” section on page 1-7.
To Next Page
Loading...
Need help?
General