Cisco Catalyst 3750-X Message Guide

2-9
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
OL-9772-05
Chapter 2 Message and Recovery Procedures
BACKUP_INTERFACE Messages
Error Message AUTHMGR-7-RESULT: Authentication result [chars] from [chars] for
client [chars] on Interface [chars] AuditSessionID [chars]
Explanation The results of the authentication. The first [chars] is the status of the authentication, the
second [chars] is the authentication method, the third [chars] is the client ID, the fourth [chars] is the
interface, and the fifth [chars] is the session ID.
Recommended Action No action is required.
BACKUP_INTERFACE Messages
Error Message BACKUP_INTERFACE-5-PREEMPT: Preempting interface [chars] in backup
pair ([chars], [chars]), preemption mode is [chars]
Explanation The switch is preempting the current forwarding interface in the backup interface pair.
The first [chars] is the number of the current forwarding interface. The second and third [chars] are
the names of the interfaces in the backup pair, and the fourth [chars] is the pre-preemption mode.
Recommended Action No action is required.
Error Message BACKUP_INTERFACE-5-VLB_NON_TRUNK: Warning: Flexlink VLB is not
allowed on non-trunk ports. Please configure [chars] to be a trunk port.
Explanation Flex Link VLAN load-balancing (VLB) detects a nontrunk port. [chars] is the interface
name.
Recommended Action Change the interface to trunking mode.
BADTRANSCEIVER Messages
Error Message BADTRANSCEIVER, PHY, LOG_WARNING: An innapropriate transceiver has
been inserted in interface [chars].
Explanation A defective module is installed in the specified interface. [chars] is the interface.
Recommended Action Remove the transceiver. If it was purchased from Cisco, contact your Cisco
representative to have the transceiver replaced.

Cisco Catalyst 3750-X Specifications

General

Brand	Cisco
Model	Catalyst 3750-X
Category	Switch
Language	English