Cisco CRS Command Reference Guide

show fmgr fabqos
To display the fabric entries for QoS, use the show fmgr fabqos command in EXEC mode.
show fmgr fabqos {hw| sw} location node-id
Syntax Description
Reads from the hardware.hw
Reads from the software.sw
Identifies the location of the interface whose fabric entries you want to
display.
location node-id
Command Default
No default behavior or values
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.8.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
To see the location of all nodes installed in the router, use the show platform command.
Task ID
OperationsTask ID
readqos
Examples
The following sample output shows the fabric QoS entries from the software:
RP/0/RP0/CPU0:router# show fmgr fabqos sw location 0/1/CPU0
FABQOS ENTRIES
===============================================================================
Interface = FABQOS Feature = fabqos Direction = in
TCAM Fields:
protocol qos-group dscp exp dc cos
===============================================================================
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
114 OL-23235-03
Quality of Service Commands on the Cisco IOS XR Software
show fmgr fabqos

Cisco CRS Specifications

General

Brand	Cisco
Model	CRS
Category	Network Router
Language	English