match protocol
To identify a specific protocol as the match criterion for a class map, use the match protocol command in
class map configuration mode. To remove protocol-based match criteria from a class map, use the no form
of this command.
match [not] protocol protocol-value [protocol-value1 ... protocol-value7]
no match [not] protocol protocol-value [protocol-value1 ... protocol-value7]
Syntax Description
(Optional) Negates the specified match result.not
A protocol identifier. A single value for protocol-value (any combination of
numbers and names) can be matched in one match statement.
protocol-value
Command Default
No default behavior or values
Command Modes
Class map configuration
Command History
ModificationRelease
This command was introduced.Release 2.0
The not keyword was added.Release 3.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Definitions of traffic classes are based on match criteria, including protocols, access control lists (ACLs),
input interfaces, QoS labels, and experimental (EXP) field values. Packets satisfying the match criteria for a
class constitute the traffic for that class.
The match protocol command specifies the name of a protocol to be used as the match criteria against which
packets are checked to determine if they belong to the class specified by the class map. Available protocol
names are listed in the table that follows.
The protocol-value argument supports a range of protocol numbers. After you identify the class, you may use
the match protocol command to configure its match criteria.
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
OL-23235-03 53
Quality of Service Commands on the Cisco IOS XR Software
match protocol
To Next Page
Loading...
Need help?
General
