hw-module qos output police granularity location
To configure the policer granularity on output interfaces, use the hw-module qos output police granularity
location command in global configuration mode. To return to the default policer granularity, use the no form
of this command.
hw-module qos output police granularity [ police-rate-dev-tol ] location interface-path-id
no hw-module qos output police granularity [ police-rate-dev-tol ] location interface-path-id
Syntax Description
(Optional) Police rate deviation tolerance, as a percentage. Range: 1 to 100.
police-rate-dev-tol
Physical location of the Shared Interface Processor (SIP). Naming notation is
rack/slot/module; a slash between values is required as part of the notation.
• rack —Chassis number of the rack.
• slot —Physical slot number of the modular services card or line card.
• module —Module number. A physical layer interface module (PLIM) is
always 0.
interface-path-id
Command Default
A default police granularity of 244 kbps is applied.
Command Modes
Global configuration (config)
Command History
ModificationRelease
This command was introduced.Release 3.9.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper task
IDs. If you suspect user group assignment is preventing you from using a command, contact your AAA
administrator for assistance.
If the police-rate-dev-tol argument is not configured, a value of 2% is configured at the specified location.
Policer granularity values, whether default or configured, apply to the SIP and to all SPAs that are installed
on the SIP.
The configured policer granularity value is applied only for all future traffic policies configured on the interface.
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
28 OL-23235-03
Quality of Service Commands on the Cisco IOS XR Software
hw-module qos output police granularity location
To Next Page
Loading...
Need help?
General
