police rate
To configure traffic policing and enter policy map police configuration mode, use the police rate command
in policy map class configuration mode. To remove traffic policing from the configuration, use the no form
of this command.
police rate {value [ units ]| percent percentage | per-thousand value | per-million value} [burst burst-size
[ burst-units ]] [peak-rate {value [ units ]| percent percentage}] [peak-burst peak-burst [ burst-units ]]
no police rate {value [ units ]| percent percentage | per-thousand value | per-million value} [burst burst-size
[ burst-units ]] [peak-rate {value [ units ]| percent percentage}] [peak-burst peak-burst [ burst-units ]]
Syntax Description
Committed information rate (CIR). Range is from 1 to 4294967295.
value
(Optional) Unit of measurement for the CIR. Values can be:
• bps —bits per second (default)
• gbps —gigabits per second
• kbps —kilobits per second
• mbps —megabits per second
units
Specifies the police rate as a percentage of the CIR. Range is from 1 to 100.
See the Usage Guidelines for information on how to use this keyword.
percent percentage
Specifies the committed information rate in per thousand of the link bandwidth.
per-thousand value
Specifies the committed information rate in per million of the link bandwidth.
per-million value
(Optional) Specifies the burst size (in the specified burst-units ). Range is
from 1 to 4294967295.
burst burst-size
(Optional) Unit of measurement for the burst values. Values can be:
• bytes —bytes (default)
• gbytes —gigabytes
• kbytes —kilobytes
• mbytes —megabytes
• ms —milliseconds
• us —microseconds
burst-units
(Optional) Specifies the Peak Information Rate (PIR) in the specified units
. Range is from 1 to 4294967295.
peak-rate value
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
OL-23235-03 63
Quality of Service Commands on the Cisco IOS XR Software
police rate
To Next Page
Loading...
Need help?
General
