show policy-map targets
To display information about the interfaces on which policy maps are applied, use the show policy-map
targets command in EXEC mode.
show policy-map targets [location node-id| pmap-name name| type [ pbr |performance-traffic | redirect
| traffic ][location node-id| pmap-name name]| type qos [location node-id| pmap-name name]]
Syntax Description
(Optional) Displays information about the interfaces on which policy maps
are applied for the specified location. The node-id argument is entered in the
rack/slot/module notation.
location node-id
(Optional) Displays information about the interfaces on which the specified
policy map is applied.
pmap-name name
(Optional) Displays information about Policy-based routing (PBR).type pbr
(Optional) Displays information about the interfaces on which Realtime
Application Flow Monitoring policy maps are applied.
type performance-traffic
(Optional) Displays information about the interfaces on which QoS policy
maps are applied. This is the default type.
type qos
Command Default
The default QoS policy type is QoS.
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.8.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
For a short period of time while a QoS policy is being modified, no QoS policy is active on the interface. For
these reasons, modify QoS policies that affect the fewest number of interfaces at a time. Use the show
policy-map targets command to identify the number of interfaces that will be affected during policy map
modification.
Cisco IOS XR Modular Quality of Service Command Reference for the Cisco CRS Router, Release 4.0
130 OL-23235-03
Quality of Service Commands on the Cisco IOS XR Software
show policy-map targets
To Next Page
Loading...
Need help?
General
