Cisco NCS 1002 User Manual

RP/0/RP0/CPU0:ios# show interfaces MgmtEth 0/RP0/CPU0/0
Fri Nov 13 19:42:29.716 UTC
MgmtEth0/RP0/CPU0/0 is administratively down, line protocol is administratively down
Interface state transitions: 0
Hardware is Management Ethernet, address is badb.adba.d098 (bia badb.adba.d098)
Internet address is 10.58.227.183/24
MTU 1514 bytes, BW 100000 Kbit (Max: 100000 Kbit)
reliability 255/255, txload 0/255, rxload 0/255
Encapsulation ARPA,
Full-duplex, 100Mb/s, CX, link type is autonegotiation
loopback not set,
ARP type ARPA, ARP timeout 04:00:00
Last input never, output never
Last clearing of "show interface" counters never
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 total input drops
0 drops for unrecognized upper-level protocol
Received 0 broadcast packets, 0 multicast packets
0 runts, 0 giants, 0 throttles, 0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 total output drops
Output 0 broadcast packets, 0 multicast packets
0 output errors, 0 underruns, 0 applique, 0 resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
a) In the above result, the management interface is administratively down. Use the no shut command to enable the
management interface.
The following example shows sample output from the show running-config interface mgmtEth command when
the management interface is in the no shut state.
RP/0/RP0/CPU0:ios#show running-config interface mgmtEth 0/RP0/CPU0/0
Fri Nov 13 19:42:54.368 UTC
interface MgmtEth0/RP0/CPU0/0
ipv4 address 10.58.227.183 255.255.255.0
!
You can also use the show interfaces summary and show interfaces brief commands in the Cisco IOS XR EXEC mode
to verify the management interface status.
• The following example shows sample output from the show interfaces summary command.
RP/0/RP0/CPU0:ios# show interfaces summary
Sun Nov 15 19:31:46.469 UTC
Interface Type Total UP Down Admin Down
-------------- ----- -- ---- ----------
ALL TYPES 2 2 0 0
--------------
IFT_ETHERNET 1 1 0 0
IFT_NULL 1 1 0 0
• The following example shows sample output from the show interfaces brief command.
RP/0/RP0/CPU0:ios# show interfaces brief
Sun Nov 15 19:31:41.806 UTC
Intf Intf LineP Encap MTU BW
Name State State Type (byte) (Kbps)
--------------------------------------------------------------------------------
Nu0 up up Null 1500 0
Troubleshooting Guide for Cisco NCS 1002, IOS XR Release 6.3.x
9
General Troubleshooting
Troubleshooting the Management Interface

Cisco NCS 1002 Specifications

General

Brand	Cisco
Model	NCS 1002
Category	Network Hardware
Language	English