Cisco NCS 1002 User Manual

Mg0/RP0/CPU0/0 up up ARPA 1514 100000
Step 2 When the line protocol is down, you must verify the Layer 3 connectivity. You can perform the following steps.
a) Check the Ethernet cable connection and physical connectivity of the NCS 1002 to get the line protocol up.
b) Ensure ARP connectivity.
c) Use the ping command to check reachability and network connectivity on the IP network.
d) Verify the static IP and default gateway configuration.
Troubleshooting Slice Provisioning
Step 1 show hw-module slice slicenumber
Displays details of the slice provisioning.
Example:
RP/0/RP0/CPU0:ios# show hw-module slice 3
Fri Nov 6 10:12:16.684 UTC
Slice ID: 3
Status: Provisioning Failed [ETNA Config Failure]
Client Bitrate: 100
Trunk Bitrate: 100
In the above example, the slice provisioning has failed because of an ETNA configuration failure.
Some of the failure reasons that can appear in the command output are:
• CFG INIT Config Failure—Indicates DP FPGA download issue.
• PPM Config Failure—Indicates PPM Driver failure.
• CDR Config Failure—Indicates CDR failure.
• ETNA Config Failure—Indicates ETNA device or programming failure.
• DP FPGA Config Failure—Indicates DP FPGA programming failure.
Step 2 upgrade hw-module slice slice_number re-provision
Reprovisions the slice.
Step 3 Reload the Cisco IOS-XR if reprovisioning the slice does not work.
Troubleshooting Environmental Parameters
Some of the common environmental problems are listed below.
• Fan failure
Troubleshooting Guide for Cisco NCS 1002, IOS XR Release 6.3.x
10
General Troubleshooting
Troubleshooting Slice Provisioning

Cisco NCS 1002 Specifications

General

Brand	Cisco
Model	NCS 1002
Category	Network Hardware
Language	English