Cisco NCS 560-4 User Manual

Table 25: Power and Status LEDs Combination
CommentIndicationSTAT LED
State
PWR LED
State
Image validation failed. System is in hung
state.
Power is OK and the
field-programmable gate array (FPGA)
is nfigured successfully, but FPGA
image validation failed.
RedLight
Green
System is up with ROMMON. Both the
FPGA image is validated successfully, but
the booted ROMMON (primary or
secondary) is undetermined.
FPGA configured and core validated
successfully.
FPGA image passed the control to
micro-loader to boot ROMMON.
OffFlashing
Light
Green and
Green
alternatively
System is up with ROMMON. FPGA
image is validated successfully, but the
booted ROMMON (primary or secondary)
is undetermined.
The digital code signing functionality
reported upgrade FPGA image
validation error and is continuing with
the FPGA image.
Amber
FPGA is up but both primary and
secondary ROMMON failed. System is in
hung state.
The digital code signing functionality
reported failure in the ROMMON
image validation.
Red
IOS writes into FPGA register to indicate
that it has booted, FPGA stops flashing
PWR LED and turns Green. Software now
controls the STAT LED.
IOS is successfully bootedOffGreen
Interface Module LEDs
Table 26: Interface Module LED Details
Description
(1x100G/200G)
Description (8/16x1G
+ 1x10G)
Description (8x10G)Description (2x100G)Color/StateLED
N560-IMA1WA900-IMA8CS1Z-MA900-IMA8ZN560-IMA2C—PID
No power to IMDisabled/no power to
IM
Disabled/no power to
IM
Disabled/no power to
IM
OffPower
(PWR)
All power rails are
in range
Enabled and power
rails on IM in range
Enabled and power
rails on IM in range
Enabled and power
rails on IM in range
Green
Cisco NCS 560-4 Router Hardware Installation Guide
114
Pinout and LED Details
Interface Module LEDs

Cisco NCS 560-4 Specifications

General

Brand	Cisco
Model	NCS 560-4
Category	Network Router
Language	English