MAC Address Tables
Querying Dynamic MAC Addresses
Cisco 220 Series Smart Switches Administration Guide Release 1.1.0.x 162
13
Querying Dynamic MAC Addresses
Use the Dynamic Address page to query the dynamic MAC addresses according
to the following criteria:
• VLAN ID
• Interface
• MAC address
This page displays the dynamically learned MAC addresses. You can clear the
dynamic addresses from the table and specify a query criteria to display a subset
of the table, such as the MAC addresses learned on a specific interface. You can
also specify how the query results are sorted. If no filter criteria is entered, the
entire table is displayed.
To query dynamic addresses:
STEP 1 Click MAC Address Tables > Dynamic Address.
STEP 2 Enter the query criteria:
• VLAN ID equals to —Check and enter the VLAN ID for which the table is
queried.
• MAC Address equals to—Check and enter the MAC address for which the
table is queried.
• Interface equals to—Check and select the interface for which the table is
queried. The query can search for specific port or LAG.
STEP 3 Click Go. The Dynamic Address Table is queried and the results are displayed.
STEP 4 If needed, select the key by which the table is sorted from the Dynamic Address
Table Sort Key drop-down menu, and click Go. The address table will be sorted
by VLAN ID, MAC address, or interface.
STEP 5 Click Clear Table to delete all dynamic MAC addresses.
To Next Page
Loading...
Need help?
General
