Cisco SG220-26P Administration Guide

Configuring Security
Configuring DHCP Snooping
Cisco 220 Series Smart Switches Administration Guide Release 1.1.0.x 220
16
• Timeout—Enter the value in seconds when to stop the database transfer
process after the DHCP Snooping binding database changes. The default is
300 seconds. The range is from 0 to 86400. Use 0 to define an infinite
duration.
STEP 3 Click Apply. The DHCP Snooping properties are defined, and the Running
Configuration is updated.
Configuring DHCP Snooping on VLANs
Use the VLAN Settings page to enable DHCP Snooping on VLANs. To enable
DHCP Snooping on a VLAN, ensure that DHCP Snooping is globally enabled on the
switch.
To define DHCP Snooping on VLANs:
STEP 1 Click Security > DHCP Snooping > VLAN Settings.
STEP 2 Select the VLANs from the Available VLANs column and add them to the Enabled
VLANs column.
STEP 3 Click Apply. DHCP Snooping is enabled on the selected VLANs, the Running
Configuration is updated.
Configuring DHCP Snooping Trusted Interfaces
Use the Interface Settings page to define the DHCP Snooping trusted interfaces.
The switch transfers all DHCP requests to trusted interfaces.
To define DHCP Snooping trusted interfaces:
STEP 1 Click Security > DHCP Snooping > Interface Settings.
STEP 2 Select the interface type (Port or LAG), and click Go.
STEP 3 Select an interface and click Edit.
STEP 4 Enter the following information:
• Trusted Interface—Select to trust or not trust the selected interface.

Cisco SG220-26P Specifications

General

Brand	Cisco
Model	SG220-26P
Category	Switch
Language	English