IP Configuration
IPv4 Management and Interfaces
293 Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3
17
-
Static
—Deletes all of the static addresses immediately.
-
Normal Age Out
—Deletes dynamic addresses based on the configured
ARP Entry Age Out time.
STEP 3 Click Apply. The ARP global settings are written to the Running Configuration file.
The ARP table displays the following fields:
• Interface—The IPv4 Interface of the directly-connected IP subnet where the
IP device resides.
• IP Address—The IP address of the IP device.
• MAC Address—The MAC address of the IP device.
• Status—Whether the entry was manually entered or dynamically learned.
STEP 4 Click Add.
STEP 5 Enter the parameters:
• IP Version—The IP address format supported by the host. Only IPv4 is
supported.
• Interface—(Layer 3 only) IPv4 interface on the device.
• VLAN—(Layer 2 only) In Layer 2, displays the management VLAN ID.
For devices in Layer 2 mode, there is only one directly-connected IP subnet,
which is always in the management VLAN. All the static and dynamic
addresses in the ARP Table reside in the management VLAN.
Interface—For devices in Layer 3 system mode, an IPv4 interface can be
configured on a port, LAG or VLAN. Select the desired interface from the
list of configured IPv4 interfaces on the device.
• IP Address—Enter the IP address of the local device.
• MAC Address—Enter the MAC address of the local device.
STEP 6 Click Apply. The ARP entry is saved to the Running Configuration file.
ARP Proxy
The Proxy ARP technique is used by the device on a given IP subnet to answer
ARP queries for a network address that is not on that network.
NOTE The ARP proxy feature is only available when the device is in L3 mode.
To Next Page
Loading...
Need help?
General
