Cisco SG500X-24P Administration Guide

SNMP
Notification Recipients
525 Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3
26
• Recipient IP Address/Name—Enter the IP address or server name of
where the traps are sent.
• UDP Port—Enter the UDP port used for notifications on the recipient device.
• Notification Type—Select whether to send Traps or Informs. If both are
required, two recipients must be created.
• Timeout—Enter the number of seconds the device waits before re-sending
informs.
• Retries—Enter the number of times that the device resends an inform
request.
• Community String—Select from the pull-down the community string of the
trap manager. Community String names are generated from those listed in
the Community page.
• Notification Version—Select the trap SNMP version.
Either SNMPv1 or SNMPv2 may be used as the version of traps, with only a
single version enabled at a time.
• Notification Filter—Select to enable filtering the type of SNMP notifications
sent to the management station. The filters are created in the Notification
Filter page.
• Filter Name—Select the SNMP filter that defines the information contained
in traps (defined in the Notification Filter page).
STEP 4 Click Apply. The SNMP Notification Recipient settings are written to the Running
Configuration file.
Defining SNMPv3 Notification Recipients
To define a recipient in SNMPv3:
STEP 1 Click SNMP > Notification Recipients SNMPv3.
This page contains recipients for SNMPv3.
STEP 2 Click Add.
STEP 3 Enter the parameters.
• Server Definition—Select whether to specify the remote log server by IP
address or name.

Cisco SG500X-24P Specifications

General

Brand	Cisco
Model	SG500X-24P
Category	Switch
Language	English