Voice Settings
Provisioning
115 Services Ready Platform SRP 500 Series Administration Guide
6
Report Rule The target URL to which configuration reports are sent.
This parameter has the same syntax as the Profile_Rule
parameter, and resolves to a TCP/IP command with an
associated URL.
A configuration report is generated in response to an
authenticated SIP NOTIFY message, with Event: report.
The report is an XML file containing the name and value
of all the device parameters.
This parameter may optionally contain an encryption
key.
For example:
[ --key $K ] tftp://ps.callhome.net/$MA/rep.xml.enc
The default is (empty).
Upgrade Enable Enables firmware upgrade operations independently of
resync actions.
The default is Yes.
Upgrade Error Retry
Delay
The upgrade retry interval (in seconds) applied in case
of upgrade failure. The device has a firmware upgrade
error timer that activates after a failed firmware upgrade
attempt. The timer is initialized with the value in this
parameter. The next firmware upgrade attempt occurs
when this timer counts down to zero.
The default is 3600 seconds.
Downgrade Rev
Limit
Enforces a lower limit on the acceptable version number
during a firmware upgrade or downgrade. The device
does not complete a firmware upgrade operation unless
the firmware version is greater than or equal to this
parameter.
The default is (empty).
Upgrade Rule This parameter is a firmware upgrade script with the
same syntax as Profile_Rule. Defines upgrade
conditions and associated firmware URLs.
The default is (empty).
Field Description
To Next Page
Loading...
Need help?
General
