Cisco XR 12000 Series Hardware Installation Guide

CHAPTER
4-1
Cisco XR 12000 Series Router SIP and SPA Hardware Installation Guide
OL-17438-04
4
Installing and Removing a SPA Interface
Processor
This chapter describes how to install or remove SIPs on the Cisco XR 12000 Series Router. This chapter
contains the following sections:
• Handling SIPs, page 4-1
• Removing and Installing a SIP, page 4-2
Handling SIPs
Each SIP circuit board is mounted to a metal carrier and is sensitive to electrostatic discharge (ESD)
damage. Before you begin installation, read “Preparing to Install a Shared Port Adapter or a SPA
Interface Processor” for a list of parts and tools required for installation.
Caution Always handle the SIP by the carrier edges and handle; never touch the SIP components or connector
pins. (See Figure 4-1.)
When a slot is not in use, a blank must fill the empty slot to allow the router to conform to
electromagnetic interference (EMI) emissions requirements and to allow proper airflow across the
installed modules. If you plan to install an SIP in a slot that is not in use, you must first remove the blank.

Cisco XR 12000 Series Specifications

General

Brand	Cisco
Model	XR 12000 Series
Category	Network Router
Language	English