To Next Page

To Previous Page

IGS-NT Communication Guide

5.1.3 InteliVision 5 display

Controllers

Controllers IG-NT-BB IM-NT-BB IG-NTC-BB IS-NTC-BB IM-NTC-BB

Connectionapplicable YES YES YES YES YES

Physical port RS485 (1) RS485 (1) RS485 (1) RS485 (1) RS485 (1)

More info

IG/IM-NT-BB - Terminal

(page 17)

IG/IS/IM-NTC-BB - Terminals (page 13)

Controllers IG-NT IM-NT IG-NTC IS-NT-BB

Connectionapplicable YES YES YES YES

Physical port RS485 (1) RS485 (1) RS485 (1) RS485 (1)

More info IG/IM-NT-BB - Terminal (page 17)

IG/IS/IM-NTC-BB - Terminals (page

13)

It is possible to connect up to 3 InteliVision 5 displays to RS485(1) terminal Link (IG/IS/IM-NTC-BB -

Terminals (page 13)).

Note: Connection InteliVision 5 to IG/IS-NT controllers is described in InteliVision5 Global Guide.

Controller setup

(Setpoints/Comms settings group)

RS485(1) conv. = DISABLED

5.2 Comms extension - I-LB+ Local bridge

I-LB+ is communication modules for communication with all devices connected to CAN(2) bus. I-LB+ is

successors of the IG-MU unit designed to be used with IG/IS controllers. It therefore provides additional

communication port and higher communication speed. Speed for direct/modem connection can be up to 57600

bps. I-LB+ can be connected with PC via USB, RS232 or RS485. I-LB+ is with USB port (speed ≈ 115200 bps).

ComAp InteliSys NTC BaseBox User Manual

Questions and Answers: