Cub Cadet SC2450 User Manual

14-27
14. PERIODIC SERVICE
Sc2450 Operator’s Manual
■ Engine Oil
Use an oil of the viscosity appropriate for the air
temperature range expected until the next oil change
interval.
Engine crankcase
■ Change the Engine Oil
●When draining away the engine oil that is still
hot, stay clear of the hot engine oil and other
components to avoid burn.
IMPORTANT: Avoid damage.
●Change the engine oil more frequently if the tractor
is used in extremely demanding conditions:
• Extremely dusty conditions
• Frequent slow- or low-speed operation
• Frequent short trips
1. Run the engine to warm up the engine oil.
2. Park the tractor safely on a level surface.
3. Open the hood.
4. Place an engine oil pan beneath the engine oil
drain plug.
(A) Drain plug
5. Remove the drain plug by turning
counterclockwise and allow the oil to drain.
6. Reinstall the drain plug. Do not over-tighten it.
7. Remove the oil fill cap.
8. Add approximately 2.2 US qt. (2.1 L) of the
engine oil.
9. Reinstall the oil fill cap.
10.Start and idle the engine to check for any leaks.
11.If there is any leakage, stop the engine, close the
hood and contact your local Cub Cadet Yanmar
for technical assistance.
12.Check the engine oil level and add more as
necessary.
13.Close the hood.
5. Every 100 Hours
Capacities Lubricants
Approximately
2.2 US qt. (2.1 L)
API Service Classifications
CF or higher
SAE 10W-30 or SAE 10W-40
3013738
The following oils are recommended:
! WARNING! WARNING
(A)
P3014926

Cub Cadet SC2450 Specifications

General

Brand	Cub Cadet
Model	SC2450
Category	Lawn Mower
Language	English