9-5
9. POWER TAKE OFF (PTO)
Sc2450 Operator's Manual
IMPORTANT: Avoid damage.
●Observe the driveline manufacturer's installation
instructions for driveline mounting angle and the
length of overlaps on the two-part driveline shafts.
An incorrectly installed implement can promote
wear of the driveline and/or damage the tractor.
●Use EXTREME caution to check that anyone or
any object is not present in the rear area when
using the Power Take Off (PTO) in reverse.
Normally, reversing the tractor stops the Mid-Power
Take Off (PTO) and the Rear Power Take Off (PTO).
To drive the Power Take Off (PTO) while reversing
the tractor, observe the following instructions:
1. Press the reverse-override-switch to enable the
reverse override function.
2. The switch illuminates and the Mid-Power Take
Off (PTO) and the Rear Power Take Off (PTO)
can be driven during reverse movement.
(A) Reverse-override-switch
●Once the reverse-override-switch is activated,
the reverse override function cannot be
disabled unless the engine is stopped.
2. Install an Implement to the Power Take Off (PTO) Drivelines
3. Operate the Power Take Off (PTO) while the Tractor is Traveling
in the Reverse Direction (Reverse Override Function)
! WARNING! WARNING
3014919f
(A)
! CAUTION
To Next Page
Loading...
Need help?
General
