Cub Cadet SC2450 User Manual

11-1
11. HYDRAULIC SYSTEM
Sc2450 Operator's Manual
11. HYDRAULIC SYSTEM
ALWAYS fully release the internal
hydraulic pressure before
disconnecting a hydraulic line.
ALWAYS ensure that all
connections are tight and all the
hydraulic lines, pipes and hoses are free from wear
or damage.
IMPORTANT
●NEVER operate the 3-point hitch control/cutting
height adjustment lever before the engine has
been sufficiently warmed up.
●If the 3-point hitch control/cutting height adjustment
lever is operated before the engine has been
warmed up, the hydraulic system can be damaged
or develop a failure.
●If abnormal hydraulic noise occurs after the 3-point
hitch has been raised, then misadjustment or failure
of the hydraulic system should be suspected.
In such a case, immediately stop operation and
contact your local Cub Cadet Yanmar dealer to
service or repair the tractor.
■ Operate the 3-Point Hitch Control/Cutting Height Adjustment Lever to Raise or Lower
the 3-Point Hitch
Use the 3-point hitch control/cutting height
adjustment lever, when raising or lowering the mid-
or rear mounted implement.
1. Shift the 3-point hitch control/cutting height
adjustment lever to the intended position.
2. Adjust the position stop knob to set the lowest
position of the implement to the desired height.
(A) 3-point hitch control/cutting height
adjustment lever
(B) Position stop knob
(a) Moving the 3-point hitch control/cutting height
adjustment lever forward will lower the
implement.
(b) Moving the 3-point hitch control/cutting height
adjustment lever backward will raise the
implement to raise higher.
! WARNING! WARNING
1. 3-Point Hitch Control System
3014918c
(A)
(b)
(a)
(B)

Cub Cadet SC2450 Specifications

General

Brand	Cub Cadet
Model	SC2450
Category	Lawn Mower
Language	English