14-34
14. PERIODIC SERVICE
Sc2450 Operator’s Manual
4. Turn the transmission/hydraulic oil filter
counterclockwise with the filter wrench to remove.
5. Install a new transmission/hydraulic oil filter and
turn clockwise by hand. Tighten the filter with a
filter wrench to a torque of 28.9 ft•lbs (4 kgf•m).
NOTE
●After hand-tightening, only tighten by 2/3 turn with
the filter wrench.
(A) Transmission/hydraulic oil filter
6. Reinstall and tighten the transmission drain plug.
7. Clean the area around the oil fill cap, then remove
the oil fill cap from the transmission housing.
8. Add approximately 2.0 US gal (7.5L) of the
transmission/hydraulic oil.
9. Reinstall the oil fill cap.
10.Start the engine and idle it for about 40 seconds.
11.Run the engine at the high idle speed for about 40
seconds.
12.Then, run the engine at the low idle speed and
slowly step on the forward and reverse drive
pedal several times.
13.Again run the engine at the high idle speed and
slowly step on the forward and reverse drive
pedal several times.
14.Stop the engine. If any leakage is found, contact
your local Cub Cadet Yanmar dealer for technical
assistance.
15.After leaving the engine for 5 minutes or more,
check the transmission/hydraulic oil level and add
more as necessary.
3014924
(A)
To Next Page
Loading...
Need help?
General
