DAP-1620 AC1300 MU-MIMO Wi-Fi Range Extender
User Manual
Configuring via Web-based Interface
IPv6
Go to the IPv6 tab to change the IPv6 address of the extender, configure IPv6 addresses assignment
settings, or specify MAC address and IPv6 address pairs.
Figure 49. Configuring the local interface. The IPv6 tab. The Local IPv6 Address section.
To change the IPv6 address of the extender, select it in the table.
Figure 50. Configuring the local interface. The IPv6 tab. The window for changing an IPv6 address.
In the opened window, you can specify the following parameters:
Parameter Description
Local IPv6 Address
IPv6 address
The IPv6 address of the extender in the local subnet. By default, the
following value is specified: fd00::1.
Prefix
The length of the prefix subnet. By default, the value 64 is
specified.
Gateway IPv6 address
The gateway IPv6 address which is used by the extender to connect
to the Internet (e.g., for synchronizing the system time with an NTP
server). Optional.
Click the APPLY button.
Page 58 of 125