DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Managed Switch
Port Mapping Priority Settings
When using the port-based priority mechanism, the port-based priority (high or low) assigned to each ingress port determines the
egress queue assigned to frames arriving via the given ingress port. The frames will be assigned to either the highest queue or the
lowest queue.
Please note the following limitation exists: port-based CoS only supports mapping to Queue 3.
Port mapping Priority Settings can be specified on this window. Select a port range using the From and To drop-down menus and
select a Class.
In the CoS folder, click Port Mapping Priority Settings, to view the window shown below:
109
To Next Page
Loading...
Need help?
General