Daikin 2MXS-W Series User Manual

Troubleshooting for Duct Concealed/Ceiling Cassette Type SiUS122226E
182 Part 6 Service Diagnosis
Note
6.10 Signal Transmission Error (Between Indoor Unit and
Remote Controller)
Error Code U5
Method of Error
Detection
In case of controlling 1 indoor unit with 2 remote controllers, check the system using microcomputer
if signal transmission between indoor unit and remote controller (main and sub) is normal.
Error Decision
Conditions
Normal transmission does not continue for specified period.
Supposed
Causes
 Connection of 2 main remote controllers (when using 2 remote controllers)
 Defective indoor unit PCB
 Defective remote controller
 Transmission error caused by noise
Troubleshooting
For the way to change MAIN/SUB setting of remote controllers, refer to pages 261 and 262.
Caution
Be sure to turn off the power switch before connecting or disconnecting
connectors, or parts may be damaged.
Are both
remote controllers set to
MAIN?
Do(es) the
indoor unit service
monitor(s) blink?
Does
operation return to
normal when the power is
turned off
momentarily?
NO
NO
YES
YES
NO
Replace the indoor unit
PCB (control PCB).
Set 1 remote controller to
SUB; turn the power supply
off once and then back on.
When using both wired and
wireless remote controllers for
1 indoor unit, make sure to set
the wireless remote controller
to SUB.
There is possibility of
malfunction caused by noise.
Check the surrounding area
and turn on again.
There is possibility of
malfunction caused by noise.
Check the surrounding area
and turn on again.
Normal
Normal
NO
NO
Using
2 remote controllers
for 1 indoor unit?
YES
YES
YES
Replace the remote controller.
Return to normal?
Return to normal?
NO
Replace the indoor unit PCB.
YES
(R24590)

Daikin 2MXS-W Series Specifications

General

Brand	Daikin
Model	2MXS-W Series
Category	Air Conditioner
Language	English