5.6 Remote Programming with MCT 10 Set-
up Software
Danfoss has a software program available for developing,
storing, and transferring frequency converter
programming. The MCT 10 Set-up Software allows the user
to connect a PC to the frequency converter and perform
live programming rather than using the LCP. Additionally,
all frequency converter programming can be done off-line
and simply downloaded to the frequency converter. Or the
entire frequency converter profile can be loaded onto the
PC for back up storage or analysis.
The USB connector or RS-485 terminal is available for
connecting to the frequency converter.
MCT 10 Set-up Software is available for free download at
VLT-software website. A CD is
also available by requesting
part number 130B1000. For further information, see the
Operating Instructions.
About Frequency Converter P...
VLT
®
HVAC Drive Operating Instructions
46 MG11AI02 - VLT
®
is a registered Danfoss trademark
55
To Next Page
Loading...
Need help?
General
