Operation Status
QStop
The motor is decelerating using 3-81
Quick
Stop Ramp Time
.
•
Quick stop inverse was chosen as a function
for a digital input (parameter group 5-1*).
The corresponding terminal is not active.
•
The quick stop function was activated via
serial communication.
Ramping The motor is accelerating/decelerating using
the active Ramp Up/Down.
The reference, a
limit value or a standstill is not yet reached.
Ref. high The sum of all active references is above the
reference limit set in
4-55 Warning Reference
High.
Ref. low The sum of all active references is below the
reference limit set in
4-54 Warning Reference
Low.
Run on ref. The frequency converter is running in the
reference range. The feedback
value matches
the setpoint value.
Run request A start command has been given, but the
motor is stopped until
a run permissive signal
is received via digital input.
Running The frequency converter runs the motor.
Sleep Mode The energy saving function is enabled. The
motor
has stopped, but
will restart automat-
ically when required.
Speed high Motor speed is above the value set in
4-53 Warning Speed High
.
Speed low Motor speed is below the value set in
4-52 Warning Speed Low
.
Standby In Auto On Auto mode, the frequency
converter starts the motor
with a start signal
from a digital input or serial communication.
Start delay
In 1-71 Start Delay, a delay starting time was
set. A start
command is activated and the
motor will start after the start delay time
expires.
Start fwd/rev Start forward and start reverse were selected
as functions for two
different digital inputs
(parameter group 5-1* Digital Inputs). The
motor starts in forward or reverse depending
on which corresponding terminal is activated.
Stop The frequency converter has received a stop
command from the LCP,
digital input or serial
communication.
Trip An alarm occurred and the motor is stopped.
Once the cause of
the alarm is cleared, the
frequency converter can be reset manually by
pressing [Reset] or remotely by control
terminals or serial communication.
Operation Status
Trip lock An alarm occurred and the motor is stopped.
Once
the cause of
the alarm is cleared, power
must be cycled to the frequency converter.
The frequency converter can then be reset
manually by pressing [Reset] or remotely by
control terminals or serial communication.
Table 7.3 Status Message Operation Status
Status Messages
VLT
®
HVAC Drive Operating Instructions
MG11AI02 - VLT
®
is a registered Danfoss trademark
53
7 7
To Next Page
Loading...
Need help?
General
