Danfoss VLT AHF 005 Programming Guide

NOTICE
An active HAND-OFF-AUTO signal via the digital inputs
has higher priority than the control keys [Hand On] –
[Auto On].
[Reset]
Press [Reset] to reset the frequency converter after an
alarm (trip). It can be selected as [1] Enable or [0] Disable
via parameter 0-43 [Reset] Key on LCP.
The parameter shortcut can be carried out by pressing the
[Main Menu] key for 3 s. The parameter shortcut allows
direct access to any parameter.
2.1.2
How to Operate Numeric LCP (NLCP)
The control panel is divided into 4 functional groups:
1. Numeric display.
2. Menu key and indicator lights (LEDs) - changing
parameters and switching between display
functions.
3. Navigation keys and indicator lights (LEDs).
4. Operation keys and indicator lights (LEDs).
NOTICE
Parameter copy is not possible with NLCP (LCP101).
Select 1 of the following modes:
Status mode: Displays the status of the frequency
converter or the motor.
If an alarm occurs, the NLCP automatically switches to
Status mode.
A number of alarms can be displayed.
Quick Set-up or Main Menu mode: Display parameters
and parameter settings.
130BA191.10
1
Auto
on
Reset
Hand
on
O
Menu
Status
Quick
Setup
Main
Menu
Back
2
3
4
OK
On
Alarm
Warn.
Setup
Illustration 2.13 Numerical LCP (NLCP)
130BP077.10
22.8
rpm
Setup 1
Illustration 2.14 Status Display Example
Indicator lights (LEDs):
•
Green LED/On: Indicates if control section is on.
•
Yellow LED/Warn.: Indicates a warning.
•
Flashing red LED/Alarm: Indicates an alarm.
Setup 1
130BP078.10
A 17
Illustration 2.15 Alarm Display Example
How to Programme
VLT
®
HVAC Drive FC 102
14 Danfoss A/S © 03/2015 All rights reserved. MG11CE02
22

Danfoss VLT AHF 005 Specifications

General

Brand	Danfoss
Model	VLT AHF 005
Category	DC Drives
Language	English