26-30 Terminal X42/5 Low Voltage 0.07 V All set-ups TRUE -2 Int16
26-31 Terminal X42/5 High Voltage 10 V All set-ups TRUE -2 Int16
26-34 Term. X42/5 Low Ref./Feedb. Value 0 N/A All set-ups TRUE -3 Int32
26-35 Term. X42/5 High Ref./Feedb. Value 100 N/A All set-ups TRUE -3 Int32
26-36 Term. X42/5 Filter Time Constant 0.001 s All set-ups TRUE -3 Uint16
26-37 Term. X42/5 Live Zero [1] Enabled All set-ups TRUE - Uint8
26-4* Analog Out X42/7
26-40 Terminal X42/7 Output [0] No operation All set-ups TRUE - Uint8
26-41 Terminal X42/7 Min. Scale 0 % All set-ups TRUE -2 Int16
26-42 Terminal X42/7 Max. Scale 100 % All set-ups TRUE -2 Int16
26-43 Terminal X42/7 Bus Control 0 % All set-ups TRUE -2 N2
26-44 Terminal X42/7 Timeout Preset 0 % 1 set-up TRUE -2 Uint16
26-5* Analog Out X42/9
26-50 Terminal X42/9 Output [0] No operation All set-ups TRUE - Uint8
26-51 Terminal X42/9 Min. Scale 0 % All set-ups TRUE -2 Int16
26-52 Terminal X42/9 Max. Scale 100 % All set-ups TRUE -2 Int16
26-53 Terminal X42/9 Bus Control 0 % All set-ups TRUE -2 N2
26-54 Terminal X42/9 Timeout Preset 0 % 1 set-up TRUE -2 Uint16
26-6* Analog Out X42/11
26-60 Terminal X42/11 Output [0] No operation All set-ups TRUE - Uint8
26-61 Terminal X42/11 Min. Scale 0 % All set-ups TRUE -2 Int16
26-62 Terminal X42/11 Max. Scale 100 % All set-ups TRUE -2 Int16
26-63 Terminal X42/11 Bus Control 0 % All set-ups TRUE -2 N2
26-64 Terminal X42/11 Timeout Preset 0 % 1 set-up TRUE -2 Uint16
5.1.25 30-** Special Features
Param
eter #
Parameter description Default value 4 set-up Change during
operation
Conversion
index
Type
30-2* Adv. Start Adjust
30-22 Locked Rotor Detection ExpressionLimit All set-ups TRUE - Uint8
30-23 Locked Rotor Detection Time [s] ExpressionLimit All set-ups TRUE -2 Uint8
Parameter Lists
VLT
®
HVAC Drive FC 102
244 Danfoss A/S © 03/2015 All rights reserved. MG11CE02
55
To Next Page
Loading...
Need help?
General