Danfoss VLT AutomationDrive FC 300 User Manual

GLCP keys
Menu keys
The menu keys are divided into functions. The keys below
the display and indicator lamps are used for parameter set-
up, including choice of display indication during normal
operation.
130BP045.10
Status
Quick
Menu
Main
Menu
Alarm
Log
Illustration 5.7
[Status]
Indicates the status of the frequency converter (and/or the
motor) or the filter respectively. On the drive LCP, 3
different readouts can be chosen by pressing the [Status]
key:
5 line readouts, 4 line readouts or Smart Logic Control.
Smart Logic Control is not available for the filter.
Use [Status] for selecting the mode of display or for
changing back to Display mode from either the Quick
Menu mode, the Main Menu mode or Alarm mode. Also
use the [Status] key to toggle single or double read-out
mode.
[Quick Menu]
Allows quick set-up of the frequency converter or the filter.
The most common functions can be programmed here.
The [Quick Menu] consists of:
- Q1: My Personal Menu
- Q2: Quick Setup
- Q5: Changes Made
- Q6: Loggings
Since the active filter is an integrated part of the Low
Harmonic Drive only a minimum of programming is
necessary. The filter LCP is mainly used to display
information about filter operation such as THD of voltage
or current, corrected current, injected current or Cos ϕ and
True Power Factor.
The Quick Menu parameters can be accessed immediately
unless a password has been created via parameters 0-60,
0-61, 0-65 or 0-66.
It is possible to switch directly between Quick Menu mode
and Main Menu mode.
[Main Menu]
is used for programming all parameters.
The Main Menu parameters can be accessed immediately
unless a password has been created via parameters 0-60,
0-61, 0-65 or 0-66.
It is possible to switch directly between Main Menu mode
and Quick Menu mode.
Parameter shortcut can be carried out by pressing down
the [Main Menu] key for 3 seconds. The parameter shortcut
allows direct access to any parameter.
[Alarm Log]
displays an Alarm list of the five latest alarms (numbered
A1-A5). To obtain additional details about an alarm, use
the arrow keys to manoeuvre to the alarm number and
press [OK]. Information is displayed about the condition of
the frequency converter or filter before it enters the alarm
mode.
[Back]
reverts to the previous step or layer in the navigation
structure.
B
a
c
k
Illustration 5.8
[Cancel]
last change or command will be cancelled as long as the
display has not been changed.
C
a
n
c
e
l
Illustration 5.9
[Info]
displays information about a command, parameter, or
function in any display window. [Info] provides detailed
information when needed.
Exit Info mode by pressing either [Info], [Back], or [Cancel].
I
n
f
o
Illustration 5.10
Navigation keys
The four navigation kays are used to navigate between the
different choices available in [Quick Menu], [Main Menu]
and [Alarm Log]. Use the keys to move the cursor.
[OK]
is used for choosing a parameter marked by the cursor
and for enabling the change of a parameter.
How to Operate the Low Harm... VLT Automation Low Harmonic Drive Operating Instructions
MG34O202 - VLT
®
is a registered Danfoss trademark 61
5 5

Danfoss VLT AutomationDrive FC 300 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300
Category	DC Drives
Language	English