4 Specifications
4.1 Electrical Data
4.1.1 Electrical Data 3x200–240 V AC
Table 4: 3x200–240 V AC
Typical shaft output [kW]
Typical shaft output [hp]
Maximum cable size in terminals (mains, compressor) [mm
2
(AWG)]
Output current @ 40 °C (104 °F) ambient temperature
Continuous (3x200–240 V) [A]
Intermittent (3x200–240 V) [A]
Output current @ 50 °C (122 °F) ambient temperature
Continous (3x200–240 V) [A]
Intermittent (3x200–240 V) [A]
Continuous (3x200–240 V) [A]
Intermittent (3x200–240 V) [A]
Maximum mains fuses, see 6.2.1 Recommendation of Fuses and Circuit Breakers
Estimated power loss [W], best case/typical
(1)
Weight enclosure protection IP20 [kg (lb)]
Efficiency [%], best case/typical
(2)
1
Applies to dimensioning of drive cooling. If the switching frequency is higher than the default setting, the power losses may increase. LCP and
typical control card power consumptions are included. For power loss data according to EN 50598-2, refer to Danfoss
MyDrive® ecoSmart website.
2
Efficiency measured at nominal current. For energy efficiency class, see
4.6 Conforming Standards. For part load losses, see Danfoss MyDrive® ecoS-
mart website.
4.1.2 Electrical Data 3x380–480 V AC
Table 5: 3x380–480 V AC
Typical shaft output [kW]
Typical shaft output [hp]
Maximum cable size in terminals (mains, motor) [mm
2
(AWG)]
AJ330233902305en-000201 / 130R0596 | 27Danfoss A/S © 2021.05
Specifications
VLT® Compressor Drive CDS 803
Design Guide
To Next Page
Loading...
Need help?
General