NOTICE
ENCLOSURE SIZE
Enclosure size designations are used throughout this
guide where procedures or components diîš„er between
drives based on size. Refer to chapter 3.4 Enclosure Size
Identication and chapter 3.5 Enclosure Size Denitions in
determining enclosure size.
13.2 E1h–E4h Disassembly and Assembly
13.2.1 General Information
These disassembly and assembly instructions apply to drives in enclosure sizes E1h–E4h. This chapter contains instructions
for disassembly and assembly of E1h–E4h drives. The instructions can be used for E-sized drives and drive modules listed in
Table 13.2.
Drive model Description
E1h drive Standard drive in an IP21/IP54 (Type 1/12) enclosure
E2h drive Larger standard drive in an IP21/IP54 (Type 1/12) enclosure
E3h drive Similar to E1h, but IP20/Chassis drive
E4h drive Similar to E2h, but IP20/Chassis drive
Enclosed drive module Similar to E3h/E4h, but includes 1 drive module in a E5h/E6h enclosed drive system
Table 13.2 E-sized Drives and Drive Modules
NOTICE
FASTENER VARIATIONS
The number of fasteners in the following procedures can vary due to the diîš„erences between enclosure sizes.
E1h–E4h Drive Disassembly a...
VLT
®
FC Series, D1h–D8h, Da2/Db2/Da4/Db4, E1h–E4h, J8/J9
260 Danfoss A/S © 02/2019 All rights reserved. MG94A502
1313
To Next Page
Loading...
Need help?
General