Output current at 40°C (104°F) ambient temperature
(1)
Intermittent (110% overload 60
s) [A]
(2)
Maximum external mains fuses
[A]
See 6.9.5 Recommendation of Fuses and Circuit Breakers.
Estimated power loss [W]
(3)
Weight enclosure protection
rating IP20 [kg (lb)]
1
Refer to the chapter Derating for the derating curves at 50°C (122°F) ambient temperature.
2
The drive also supports 150% overload for 60 s when selecting 1 level higher power size.
3
Applies for dimensioning of drive cooling. If the switching frequency is higher than the default setting, the power losses may increase. LCP and
typical control card power consumptions are included. For power loss data according to EN 50598-2, refer to Danfoss
MyDrive® ecoSmart website.
4
Efficiency measured at nominal current. For energy efficiency class, see 9.2.13 Ambient Conditions (H1–H8). For part load losses, see Danfoss My-
Drive® ecoSmart website.
Table 90: 3x380–480 V AC, 110–315 kW (150–450 hp), Enclosure Sizes H13–H14
Typical shaft output [kW]
Typical shaft output [hp]
Maximum cable size in terminals
(mains, motor) [mm
2
(AWG)]
Output current at 40°C/45°C (104°F/113°F) ambient temperature
(1)
Intermittent (110% overload 60 s)
[A]
(2)
Maximum external mains fuses
[A]
See 6.9.5 Recommendation of Fuses and Circuit Breakers.
Estimated power loss [W]
(3)(4)
AJ363928382091en-000101 / 130R0983132 | Danfoss A/S © 2021.04
General Specifications
VLT® Flow Drive FC 111
Design Guide
To Next Page
Loading...
Need help?
General