1 Safety
1.1 Disclaimer
The examples and diagrams in this manual are included solely for illustrative purposes. The information contained in this manual is
subject to change at any time and without prior notice. Responsibility or liability is never accepted for direct, indirect, or consequential
damage resulting from the use or application of this equipment.
1.2 Warnings
WARNING
UNEXPECTED BEHAVIOR
When the soft starter is connected to mains voltage, the Pumping Smart Card can start or stop the motor without warning.
Unexpected behavior can lead to personal injury.
-
To ensure personnel safety, isolate the soft starter from mains voltage before installing the smart card.
WARNING
RISK OF PERSONAL INJURY AND EQUIPMENT DAMAGE
Inserting foreign objects or touching the inside of the soft starter while the expansion port cover is open may endanger
personnel and can damage the soft starter.
-
Do not insert foreign objects in the soft starter with the port cover open.
-
Do not touch the inside of the soft starter with the port cover open.
NOTICE
The hydraulic characteristics of pump systems vary considerably. The default parameter settings may not be suitable for every
application and care should be taken to configure the soft starter appropriately.
Safety
Installation Guide | Pumping Smart Card
AN279052730268en-000102 / 175R1183 | 5
Danfoss A/S © 2018.10
To Next Page
Need help?
General
