DeLaval MPCII User Manual

Operation
DeLaval milking point controller MPCII
94381001.pdf2006-07-20
Manual forced vacuum time. This is the
maximum time during which high vacuum is
activated after you have pressed the
Manual forced vacuum button.
F323
Post-milking time. This is the duration of
the post-milking. See time A in the diagram.
This timer will restart every time the MPCII
enters post-milking phase.
F324
Take-off delay. Delay between vacuum
shut-off and retraction. See time B in the
diagram.
F325
Sweep delay. Delay between retraction and
start sweep. See time C in the diagram.
F326
Sweep duration. Time D. See ① in the
diagram.
F327
Low-flow limit/pre-milking limit. The flow
limit when the MPCII switches from
pre-milking phase to main milking phase.
F328
AlfaDast, strip time 1. See AlfaDast ST1!
F329
AlfaDast, strip time 2. See AlfaDast ST2!
F330
AlfaDast, strip time 3. See AlfaDast ST3!
F331
Duovac/Monovac. If Duovac is not used,
set this parameter to YES (= 1)
F332
Pulsator rate.
F333
Pulsator ratio.
F334
Strip limit. Used in AlfaDast only. The flow
limit when the strip is activated and the
stripping phase begins.
F335
Take-off limit/post-milking limit.
ACR has been installed: The flow limit when
73(94)

DeLaval MPCII Specifications

General

Brand	DeLaval
Model	MPCII
Category	Controller
Language	English