Dell EMC ES40 User Manual

Note: The output provides a text representation of each HBA port and the order in
which the shelf controllers are connected. If the replacement controller does not appear
in the map, then there is still an issue with this controller.
4. Enter the filesys enable command to restart the file system.
Complete the procedure
Procedure
1. Return the failed or replaced part(s) to Dell EMC. Reuse the packaging from the new
part(s) and use the included prepaid waybill for shipping. Reference the RMA number on the
outside of the package.
2. Send an autosupport report from the system by entering the autosupport send
command.
Disk Drive Replacement
This section describes how to replace a disk drive.
Identify the failed drive
Follow these steps to identify which drive failed in your system.
Procedure
1. Check the disk enclosure LEDs visible on the front panel of the shelf. Use the table to
identify the color and status.
Table 4 Status lights
Light Quantity Color Meaning
Disk enclosure
power
1 Blue Power to the enclosure is on
Disk enclosure
fault
1 Amber Lit when any fault condition exists. If the fault is
not obvious from the disk module light, look at
the back of the disk enclosure.
Disk active 1 per disk
module
Green
l
No LED when the slot is empty or has a filler
module.
l
LED off when the disk is powered down by
command; for example, the result of a
temperature fault.
l
Fast blinking when the SAS drive is powered
up but not spinning; this is a normal part of
the spin-up sequence, occurring during the
spin-up delays of a slot.
l
On when the drive has power but is not
handing any I/O activity (the ready state).
l
Slow blinking when the drive is spinning and
handling I/O activity.
Removing and replacing FRUs
Dell EMC ES40 Expansion Shelf Guide Field Replacement Unit Guide 29

Dell EMC ES40 Specifications

General

Brand	Dell EMC
Model	ES40
Category	Indoor Furnishing
Language	English