To Next Page

To Previous Page

ON switches includes four-post, two-post, round threaded holes, or square holes. The

ReadyRails system is provided for 1U front-rack and two-post installations.

Do not use the ReadyRails system for the S5296F-ON or S5212F-ON switches. For the

S5296F-ON switch, see Two U four-post rack assembly. For the S5212F-ON switch, see

One-half U front-rack installation.

The ReadyRails system includes two separately packaged rail assemblies. To begin

installation, separate each rail assembly by sliding the inside rail out of the outside rail.

WARNING: This guide is a condensed reference. Read the safety instructions in

your

Safety, Environmental, and Regulatory

information booklet before you begin.

NOTE: The illustrations in this section are not intended to represent a specic

switch.

NOTE: Do not the use the mounted ReadyRails as a shelf or a workplace.

Rack mount safety considerations

• Rack loading—Overloading or uneven loading of racks may result in shelf or rack failure,

possibly damaging the equipment and causing personal injury. Stabilize racks in a

permanent location before loading begins. Mount the components starting at the

bottom of the rack, then work to the top. Do not exceed your rack’s load rating.

• Power considerations—Connect only to the power source specied on the unit. When

you install multiple electrical components in a rack, ensure that the total component

power ratings do not exceed the circuit capabilities. Overloaded power sources and

extension cables are re and shock hazards.

• Elevated ambient temperature—If you install the switch in a closed rack assembly, the

operating temperature of the rack environment may be greater than the room ambient

temperature. Use care not to exceed the 45°C (113°F) maximum ambient temperature

of the switch.

• Reduced airow—Do not compromise the amount of airow needed for safe operation

of the equipment. Install the equipment in the rack so that the equipment constantly

has the correct amount of airow surrounding it.

• Reliable earthing—Maintain reliable earthing of rack-mounted equipment. Pay particular

attention to the supply connections other than the direct connections to the branch

circuit, for example: use of power strips.

• Do not mount the equipment with the fan panel facing in the downward position.

S5200F-ON Series switch Installation

Dell EMC S5200F-ON Series User Manual

Questions and Answers: