Diagnostic aids 3-7
Num Pad Job Assist
This setting determines if a user can configure and initiate a job using the panels hard buttons.
To change this setting:
1. Touch Num Pad Job Assist from the Configuration Menu. [setting's current value] appears on the
touch-screen.
2. Touch or . The settings are On or Off.
3. Touch Submit to save the change.
Format Fax Storage
This setting enables you to format the non-volatile storage used for storing faxes.
To change this setting:
1. Touch Format Fax Storage from the Configuration Menu.
Note: If an advanced password has been established, you must enter this password in order to change the
setting. If no advanced password exists, you can establish one by using the keyboard that appears on the LCD.
2. Touch Submit to save the change.
3. Touch Back to cancel and return to the Configuration Menu.
Formatting Fax Flash DO NOT POWER OFF appears on the LCD while the format operation is active.
Fax Storage Location
To change this setting:
1. Touch Fax Storage Location from the Configuration Menu. [setting's current value] appears on
the touch-screen.
2. Touch or . The settings are Disk and NAND.
3. Touch Submit to save the change.
ADF Edge Erase
This menu item sets the size, in millimeters, of the no-print area around an ADF scan job.All copy jobs have a
minimum of a two millimeter border. Copy jobs will use the setting or two millimeters, whichever is larger.
To adjust the ADF edge erase setting, perform the following steps:
1. Touch ADF Edge Erase from the Configuration Menu. [setting's current value] appears on the
touch-screen.
2. Touch to increase the value or to decrease the value.
3. Touch Submit to save the change.
4. Touch Back to cancel and return to the Configuration Menu.
FB Edge Erase
This menu item sets the size, in millimeters, of the no print area around a flatbed scan job. Copy jobs will use the
setting or two millimeters, whichever is larger.
To Next Page
Loading...
Need help?
General
