3-16 Service Manual
Clear Custom Status
No values exist for this operation. Pressing initiates this operation.
Touch to select Clear Custom Status from the Configuration Menu.
Note: Executing this operation erases any strings that have been defined by the user for the default or
alternate custom messages.
USB Speed
The USB Speed setting is used to set the throughput of the USB port on the MFP. The settings are Auto, which
is the default, and Full. Full forces the USB port to tun at full speed.
USB PnP
This setting is used to improve the MFP’s compatibility with the host PC.
Note: Some PCs contain chipsets that may be incompatible with this MFP.
To change this setting:
1. Touch to select USB PnP from the Configuration Menu.
2. Touch or to change the value. The values are 1 (default) and 2.
3. Touch Submit to save the change.
Touch Back to cancel and return to the Configuration Menu.
Exit Configuration Menu (Exit Config Menu)
Press to exit the Configuration menu. The printer performs a POR and restarts in normal mode.
To Next Page
Loading...
Need help?
General
