Diagnostic aids 3-15
If Standby Mode is on, the printer begins functioning in Standby Mode when it remains idle for an amount of
time. The Standby Mode enables the printer:
• To consume less energy than when operating in normal mode but not as little as when operating in Power
Saver
• To return to the Ready state more quickly than when operating in Power Saver
LES Applications
To change this setting:
1. Touch LES Applications from the Configuration Menu.
Note: If an advanced password has been established, you must enter this password in order to change the
setting. If no advanced password exists, you can establish one by using the keyboard that appears on the LCD.
2. Touch Back to cancel and return to the Configuration Menu.
3. Touch Submit to save the change.
Key Repeat Initial Delay
When a key is touched repeatedly, this is the delay before the key begins repeating. The delay ranges from .25
seconds to 5 seconds. The default is 1 second. Values are given in increments of.25 seconds.
To change this setting:
1. Touch Key Repeat Initial Delay from the Configuration Menu.
2. Touch to increase the value or to decrease the value.
3. Touch Submit to save the change.
4. Touch Back to cancel and return to the Configuration Menu.
Key Repeat Rate
This is the number of times per second that a repeating key will repeat. The range is 1–100, with a default of 15
times per second.
To change this setting:
1. Touch to select Key Repeat Initial Delay from the Configuration Menu.
2. Touch to increase the value or to decrease the value.
3. Touch Submit to save the change.
Touch Back to cancel and return to the Configuration Menu.
Wiper Message
To change this setting:
1. Touch to select Wiper Message from the Configuration Menu.
2. Touch or to change the value. The values are On (default) and Off.
3. Touch Submit to save the change.
Touch Back to cancel and return to the Configuration Menu.
This disables all installed LXK Embedded Solution applications. The default is Enabled.
To Next Page
Loading...
Need help?
General
