EasyManuals Logo

Dell OptiPlex 960 User Manual

Dell OptiPlex 960
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #102 background imageLoading...
Page #102 background image
Back to Contents Page
Dell™Optiplex™960MiniTower/Desktop/SmallFormFactorServiceManual
Small Form Factor Computer Cover
Small Form Factor Computer Cover
Removing the Small Form Factor Computer Cover
1. Perform the procedure Before Working on Your Computer.
2. If a security cable or a padlock (through the padlock ring) is attached, remove it.
3. Locate the cover release latch and slide it back as you lift the end of the cover near the latch.
4. With the cover end near the latch raised slightly, slide the cover toward the latch end of the chassis to pull the tabs at the other end of the cover out of
the slots in the chassis.
Replacing the Small Form Factor Computer Cover
1. Ensure that all cables are connected, and fold cables out of the way.
Gently pull the power cables toward you so that they do not get caught underneath the drives.
2. Ensure that no tools or extra parts are left inside the computer.
3. To replace the cover:
CAUTION: Before you begin any of the procedures in this section, read the safety information that shipped with your computer. For additional
safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the computer cover.
NOTE: For convenience, lay the computer on its side before working inside the chassis.
CAUTION: Graphics card heatsinks can become very hot during normal operation. Ensure that a graphics card heatsink has had sufficient time to
cool before you touch it.
1
padlock ring
2
cover release latch
3
security cable slot
CAUTION: Before you begin any of the procedures in this section, read the safety information that shipped with your computer. For additional
safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

Table of Contents

Other manuals for Dell OptiPlex 960

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell OptiPlex 960 and is the answer not in the manual?

Dell OptiPlex 960 Specifications

General IconGeneral
Tcase72.4 °C
Bus typeFSB
SteppingE0
Processor cache6 MB
Processor cores2
Processor modelE8400
System bus rate- GT/s
Processor familyIntel® Core™2 Duo
Processor seriesIntel Core 2 Duo E8000 Series
Processor socketLGA 775 (Socket T)
Processor codenameWolfdale
Processing Die size107 mm²
Processor frequency3 GHz
Processor cache typeL2
Processor lithography45 nm
Processor manufacturerIntel
Processor front side bus1333 MHz
Processor operating modes64-bit
ECC supported by processorNo
Thermal Design Power (TDP)65 W
Number of processors installed1
CPU multiplier (bus/core ratio)9
Number of Processing Die Transistors410 M
Internal memory4 GB
Memory clock speed800 MHz
Internal memory typeDDR2-SDRAM
Maximum internal memory16 GB
Memory layout (slots x size)2 x 2 GB
HDD speed7200 RPM
HDD interfaceSATA
Optical drive typeDVD-RW
Total storage capacity250 GB
Networking featuresGigabit Ethernet
Graphics card familyAMD
Compliance industry standardsIEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Discrete graphics card modelAMD Radeon HD 3470
Maximum graphics card memory- GB
On-board graphics card modelNot available
Discrete graphics card memory256 GB
Operating system installedWindows 7 Professional
Microphone inYes
USB 2.0 ports quantity10
Firewire (IEEE 1394) ports0
Ethernet LAN data rates10, 100, 1000 Mbit/s
Chassis typeSFF
Product colorBlack
Product typePC
Processor codeSLB9J
Processor ARK ID33910
Processor package size37.5 x 37.5 mm
Weight and Dimensions IconWeight and Dimensions
Depth323 mm
Width85 mm
Height289 mm
Weight5900 g

Related product manuals