Replacing the camera
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1 Connect the camera cable to the camera.
2 Using the alignment post, place the camera on the display-back cover
and snap it into place.
3 Slide the display cable into its slot on the display-back cover and close
the latch to secure the cable.
4 Adhere the tape on the display-cable connector.
5 Adhere the tape to secure the display cable to the display panel.
6 Slide the sensor-board cable into its slot on the sensor board and close
the latch to secure the cable.
Post-requisites
1 Replace the display panel.
2 Replace the display assembly.
3 Replace the wireless card.
4 Replace the battery.
5 Replace the base cover.
84
To Next Page
Loading...
Need help?
General
