Dell PowerConnect 2808 User Manual

Dell PowerConnect 28xx Systems User Guide 163
• prefix-length —Range: 8-30
•
default-gateway ip-address —Valid IP address
Defaults
No IP address is defined for interfaces
Command Modes
Interface Configuration VLAN mode.
User Guidelines
• Assigning an IP address to an interface does not disable L2 protocols, such as STP.
• Defining a static IP address on an interface implicitly removes the DHCP client configuration on the
interface.
• Interface context may be VLAN 1 only
Examples
switch(config)> interface vlan 1
switch(config-if)> ip address 131.108.1.27 255.255.255.0 default-gateway
131.108.1.1
Command: ping
Use the ping command to send ICMP echo request packets to another node on the network.
ping {
ip-address | hostname } [size packet_size ] [count packet_count ] [timeout time_out ]
Syntax Description
• ip-address — IP address to ping.
•
hostname — Hostname to ping.
•
packet_size — Number of bytes in a packet. The default is 56 bytes. The actual packet size will be
eight bytes larger than the size specified because the switch adds header information.
•
packet_count — Number of packets to send, from 1 to 65535 packets. The default is 4 packets. If 0 is
entered it pings until stopped.
•
time_out — Timeout in milliseconds to wait for each reply, from 50 to 65535 milliseconds. The default
is 2000 milliseconds.
Parameters range
• hostname — 1 - 158 characters (Max label size: 63)
•
packet_size — IPv4: 56 - 1472

Dell PowerConnect 2808 Specifications

General

Brand	Dell
Model	PowerConnect 2808
Category	Switch
Language	English