Dell PowerConnect 2808 User Manual

Dell PowerConnect 28xx Systems User Guide 167
• rw — Specifies read-write access
•
su — Specifies SNMP administrator access
•
ipv4-address — Management station IPv4 address. Default is all IP addresses.
Parameters range
• community — 1 - 20 chars
•
ip-address — Valid IP address
Default
No community is defined
Command Mode
Global configuration
Usage Guidelines
The logical key of the command is the pair (community, ip-address). If ip-address is omitted then the key
is (community, All-Ips).
Examples
Switch(conf)# snmp-server community public
Command: username
To establish a username-based authentication system, use the username command in global
configuration mode. Use the no form to remove a user name.
username name [password
password ] [level level ] [encrypted]
no username
name
Syntax Description
• name — The name of the user.
•
password — The authentication password for the user.
•
level — Specifies the user level. If not specified the privilege level is 1.
•
encrypted — Encrypted password you enter, copied from another device configuration.
Parameters range
• name — 1 - 20 characters.
•
password — 1 - 159
•
level — 1 - 15

Dell PowerConnect 2808 Specifications

General

Brand	Dell
Model	PowerConnect 2808
Category	Switch
Language	English