40 Using the System Setup Program
As you press each character key (or the spacebar for a blank space), a placeholder appears in the field.
The password assignment is not case-sensitive. However, certain key combinations are not valid. If you enter
one of these combinations, the system beeps. To erase a character when entering your password, press
<Backspace> or the left-arrow key.
After you verify the password, the
Setup Password
setting changes to
Enabled
. The next time you enter the
System Setup program, the system prompts you for the setup password.
A change to the
Setup Password
option becomes effective immediately (restarting the system is not
required).
Operating With a Setup Password Enabled
If
Setup Password
is set to
Enabled
, you must enter the correct setup password before you can modify most
of the System Setup options. When you start the System Setup program, the program prompts you to enter
a password.
If you do not enter the correct password in three attempts, the system lets you view, but not modify, the
System Setup screens—with the following exception: If
System Password
is not set to
Enabled
and is not
locked through the
Password Status
option, you can assign a system password (however, you cannot disable
or change an existing system password).
NOTE: You can use the Password Status option in conjunction with the Setup Password option to protect the
system password from unauthorized changes.
Deleting or Changing an Existing Setup Password
1
Enter the System Setup program and select the
System Security
option.
2
Highlight the
Setup Password
option, press <Enter> to access the setup password window, and press
<Enter> twice to clear the existing setup password.
The setting changes to
Not Enabled
.
3
If you want to assign a new setup password, perform the steps in "Assigning a Setup Password" on
page 39.
Disabling a Forgotten Password
See
"Disabling a Forgotten Password
" on page 101
.
Baseboard Management Controller Configuration
The Baseboard Management Controller (BMC) enables configuring, monitoring, and recovery of systems
remotely. BMC provides the following features:
• Uses the system’s serial port and integrated NIC
• Fault logging and SNMP alerting
• Access to system event log and sensor status
To Next Page
Loading...
Need help?
General
