Dell PowerEdge 860 User Manual

62 Installing System Components
Figure 3-13. Installing and Removing the Power Supply
Installing the Power Supply
1 Lower the power supply into the chassis and slide it backward until the four pins on the power supply
are engaged into the securing brackets.
2 Using a #2 Phillips screwdriver, install the screw at the front of the power supply that secures the
power supply to the chassis.
1 screw 2 P1 connector 3 P2 connector
4 power supply 5 pins (4) 6 securing brackets (4)
7 P3 connector
7
5
6
1
2
3
4

Dell PowerEdge 860 Specifications

General

Chipset	Intel 3000
Form Factor	1U Rack
Processor Socket	LGA 775
Number of Processors Supported	1
Memory Slots	4
Processor	Intel Xeon 3000 series
Memory	Up to 8GB
RAID Support	PERC 5/i
Network	Embedded Broadcom Gigabit Ethernet
Memory Type	DDR2
Hard Drive Interface	SATA
Maximum Internal Storage	Up to 2TB
Power Supply	305W
Operating System Support	Red Hat Linux