Dell PowerVault ML6000 User Manual

Enter EKMAdmin for the User Name. The initial password is changeME. After you
are logged in, you can use the chgpasswd command to change the password.
See “chgpasswd” on page 5-9.
Note: v The Dell Encryption Key Manager GUI may not be capable of
displaying the host IP address
Two limitations in the current GUI prevent it from displaying the
Encryption Key Manager host IP address in the Server Health Monitor :
v The current application does not recognize IPV6. If the host is
configured with an IPV6 address, the Encryption Key Manager
application will not be able to display the IP address.
v If the Encryption Key Manager application is installed in a Linux
system, the application displays the localhost address and not the
actual active IP port.
To retrieve the actual IP address of the host system, locate the IP port
address by accessing the network configuration. In a Windows system
open a command window and enter ipconfig. For Linux enter isconfig.
6. Click Login.
Use the same Server Status page to stop the server.
Starting the Key Manager Server Using a Script
On Windows
Navigate to cd c:\ekm\ekmserver and click startServer.bat
On Linux platforms
Navigate to /var/ekm/ekmserver and enter . ./startServer.sh
To stop the server, issue the stopekm command using any of the methods
described below in “The Command Line Interface Client” on page 5-5. Another
method is to send a sigterm to the key manager process. This allows the server to
a14m0250
Figure 5-2. Login Window
5-2 Dell Encryption Key Mgr User's Guide

Dell PowerVault ML6000 Specifications

General

Brand	Dell
Model	PowerVault ML6000
Category	Storage
Language	English