Chapter 4 Operating ISPSoft
4-7
4.4.2 Setting the Parameters in a CPU and a Module
After AH16AP11R-5A is configured, you can set the parameters in the CPU module and the parameters in the extension
module. Afteryou double-click the CPU module or the extension module, a corresponding window will appear.
After the CPU module is double-clicked, the PLC Parameter Setting window will appear. You can click the primary tabs at
the top of the window, and the secondary tables at the bottom of the window to set the parameters. In this example, you
only need to define the name of the CPU module.
After you click the CPU tab at the top of the window, and the Name tab at the bottom of the window, you can type a name
in the Name box. You will find the default name in the Name box is the same as the project name. Delete the default name,
type “Main_Controller” in the Name box, and click OK.
After you double-click AH16AP11R-5A, the Parameter Setting window will appear.
After the Parameter Setting window is opened, you can view the information related to the module. You can select the
parameter type at the left side of the window, and then set the parameter in the table at the right side of the window.
In this example, the default values are retained. Therefore, the step of setting the parameter in AH16AP11R-5A is skipped.
To Next Page
Loading...
Need help?
General
