Delta AS01DNET-A User Manual

Chapter 13 IO-Link Communication Module AS04SIL
13-3
13
13.1 Overview
Thank you for using the IO-Link master module AS04SIL-A. To ensure that your AS04SIL-A is installed and operated
correctly, read this manual carefully before using the module.
The AS04SIL-A module is an AS series IO-Link communication module (hereafter referred to as “SIL” module) connected
on the right side of AS CPU module or AS00SCM-A (RTU mode). When the communication card AS-FCOPM is being used
together, they serve as a CAN remote device. SIL provides 4 channels, which can be separately configured in IO-Link
master or standard I/O (SIO) mode. IO-Link master can freely connect with IO-Link devices and supports the hybrid use of
IO-Link sensors and traditional sensors. Digital I/O of the SIL module can be extended with IO-Link hubs so that the sensors
which do not support IO-Link can be connected to. Therefore it is pretty flexible to use the SIL module.
The setup software for AS04SIL-A is HWCONFIG 4.0 which is built in ISPSoft. You can use it after downloading the
software from Delta official website and installing it.
13.1.1 Firmware and Software Versions
Firmware
Model
AS series CPU
AS00SCM-A
AS04SIL-A
Version
V1.08 and later
V2.06 and later
V1.00 and later
Software
Model
ISPSoft
HWCONFIG 4.0
AS00SCM-A CANopen EDS file
Version V3.11 and later V4.03 and later V2.06 and later

Delta AS01DNET-A Specifications

General

Brand	Delta
Model	AS01DNET-A
Category	Network Hardware
Language	English